Νομίζω πρέπει να ξεκινήσεις από το κόστος!
Οι σωλήνες φθορίου κοστίζουν €1-2 και τα starter €0.50. Αρα με €5-10 ... καθάρισες.
Οι λαμπτήρες "LED tube retrofit" (σωλήνες με LED) ξεκινούν από €16 μαζί με τον βραχυκυκλωτήρα του παλιού starter.
Προσοχή όμως! Μπορείς να τις βάλεις σε αντικατάσταση σωλήνας φθορίου που έχει ένα ballast για κάθε λαμπτήρα και όχι εκεί που έχει ένα ballast σε 2 λαμπτήρες. Επίσης δεν λειτουργούν με ηλεκτρονικούς εκκινητές.
Από το:
http://www.osram.com/media/resource/hir ... hb4-gb.pdf
SubstiTUBE ® Basic – ST8-HB4 (Datasheet)
Innovative LED-lamp, easy and safe to use in CCG installations as direct retrofit. Energy saving potential of up to 52% by replacing 1.2 m T8 fluorescent tubes. Instant 100% light without flickering. No mercury. Applicable in warehouses, cold storage, supply rooms, corridors, industry, stairways, garages, indirect llumination etc; for applications with high operating hours.
Technical operating data
...
ST8-HB4-190-830 Warm White 3000 K 1900 lm
230V (200-240V) 50/60Hz 0.09A 21W 150°
...
For operation at magnetic ballast ... replacement of lamp and included starter, overpower, overheat and short circuit protected
No rewiring necessary at CCG
... Fully integrated ECG complies to relevant standards
Not for operation with ECG, not dimmable
...
Not usable in luminaires with serial lamp connection i.e. more than one tube at one magnetic ballast (tandem circuitry).
The SubstiTUBE ® Basic emits light only with a limited angle, not like a fluorescent tube with 360°output.
Due to the characteristic light distribution of the SubstiTUBE ® Basic, the resulting luminaire light characteristic is likely to change. It is not guaranteed that e.g. standards for lighting at working places will be complied to after replacement. A photometric check of the installation is recommended.
The effective energy savings depend on the efficiency of the luminaire setup to be replaced and should be considered individually in each case.
Particularly magnetic ballast losses are reduced to ohmic losses and are normally only about 1 W.
...
Δηλαδή, μπαίνουν στη θέση απλών κυκλωμάτων (1 ballast για κάθε λάμπα), χάνεις μόνο 1W από το ballast, για την αντίστοιχη μήκους 120cm προτείνουν 1900+ lumen με κατανάλωση 21W+1 από το ballast, άρα το "up to 52%" γίνεται 38% και τέλος ... "A photometric check of the installation is recommended." δηλαδή "μη περιμένεις να φέγγει και το ίδιο"!
Αν επιμένεις και ρωτάς και πόσο κάνει ένας σωλήνας OSRAM ... λίγο περισσότερα από €40.
Νομίζω ότι δεν έχει νόημα να μπει σε οικιακό περιβάλλον. Αν μάλιστα πρόκειται για κρυφό φωτισμό, απλά το ξεχνάς.
Η έννοια του "retorfit" για σωλήνες με LED πρέπει να συμφέρει σε αποθήκες, νοσοκομεία κλπ. που λειτουργούν 24 ώρες την ημέρα, μαυρίζουν, τρεμοσβήνουν, καίγονται και το εργατικό κόστος αλλαγής τους είναι μεγάλο.
Γενικά, όσον αφορά την καλωδίωση, η γνώμη μου είναι: φτιάξε το κύκλωμα από την αρχή
Το ίδιο αναφέρει σε datasheet της Philips:
http://www.lighting.philips.com/us_en/c ... v6_web.pdf
During retrofit,
rewiring is a MUST, please follow the installation steps below.
Υ.Γ. πώς και δεν πήρες τηλέφωνο;